Your Artwork... First Make Your Copy On Your Computer. You Can Make Any Black And White Line Drawing, Logo, Trademark or Simple Message You Wish. Do NOT Use Colored Ink As It Does Not Work Well With U.V. Light. (Also Photos Don't Work.

Transparency... Next Print Out Your Copy On A Transparency (Which Comes In The Kit) And Place The Transparency Copy On Your Choice Of Sign Material (Which Comes In The Kit)

Glass Compression Plate... Place The Heavy Duty Glass Plate On Top Of Transparency And Sign or Label Sheet To Hold In Place While Exposing To Ultra-Violet Light. (The U.V. Light Will NOT Hurt You But You Should Not Spend Time Looking At It.

Timer... Next, Set Your Timer For 3 Minutes And Turn On The Exposure Unit. After 3 Minutes Turn Off The Sign-O-Matic And Remove The Aluminum Sheet.

Develop... Wash Your Sign or Label Very Gently In Plain Water For About 30 Seconds To A Minute Using A Soft White Sponge Found In The Kit.

NEXT... In SECONDS You Will See The Sign Appear Like Magic As You Gently Wash It!

Dryer... The Last Step Is To Dry Your Sign Or Label. (Note: You Can Put The Aluminum Sheet Back In The Sign-O-Matic After It Is Dry For About 3 Minutes To "HARDEN" The Surface To Get Longer Wear Or Use An "Overlay Sheet" Found Below.

Ready To Use... All Finished In Less Than 5 Minutes! And Remember It Also Makes Stencils That Let You Etch Metal & Glass And Paint On Wood, Plastic, Fabric Or Anything That Will Take Paint! (Click Here For More Info On Stencils)